Kudo3D Titan 1 - Build Manual
Ver. 1.1
23
of
33
III. Installing the Resin Container
WARNING
: The PSP resin container is delicate and susceptible to the oils on fingers and hands. Only hold the
PSP resin container using the front or back walls.
DO NOT TOUCH
the side walls (film), the inside, or the bottom
of the container.
1. Using the
3mm T-ball Headed Allen wrench (Orange handle)
, loosen the screws on the resin container
bar (Do Not completely unscrew) and put the side of the resin container that has a bottom edge below the
resin container bar.
Note
: Make sure the resin container is flush with the bar and pushed all the way up to the hex screw head
on the front left of the printer box.
2. Slightly tighten the two screws on the bar when the resin container is in place.
