Kudo3D Titan 1 - Build Manual
Ver. 1.1
32
of
33
Note
: This represents a 100 micron XY resolution.
10.
Under the Control tab under the Projector Control section in the Kudo3D software, click “Go Z-Home”.
11. Adjust the build platform so that none of the light escapes.
Bad
Good
Additional projector calibration explanation and tip:
The ruler provided is only for calibrating the size of the projected image (resolution) after being cut into a 20 cm
by 11 cm grid.
Size calibration
can be performed with a coarse focusing on the ruler.
To calibrate the size, tighten only one screw on one end of the projector supporting steel plate with the orange
wrench provided. Put the bubble level on top of the projector and move the other end of the steel plate to level
the projector. Then tighten one screw on the other end now. Check the image size. If it is not
well calibrated, redo the step above. After the size and level are calibrated, tighten the rest two screws on the
steel plate. Remove the ruler after the size calibration is done.
