Kubota U50-5, Руководство по эксплуатации

Страница: 110 / 236

108
W9272-8135-1
05/2020
Operation
Blocking and releasing the particle filter regeneration - Procedure

Press the inhibit switch (1).
The automatic particle filter regeneration is locked and the indicator
lights up on the display.
The particle filter regeneration must be performed in certain inter-
vals. If the automatic particle filter regeneration has been locked
and the particle filter is fully saturated with soot, the operator is
prompted to enable particle filter regeneration.
The display message as in the figure on the right appears. In addi-
tion, the yellow warning light flashes and an audible signal is emitted
at brief intervals.

Press the inhibit switch (1).
The indicator goes out and regeneration starts.
If the particle filter regeneration is not released using the switch, the
degree of saturation in the particle filter continues to increase.
The engine power of the machine is reduced to prevent damage to
the particle filter.
The display message as in the figure on the right appears. In addi-
tion, the red warning light flashes and an audible signal is emitted at
intervals.

Press the inhibit switch (1).

Raise engine speed.

Continue the operation.
The indicator in the switch stops glowing. The particle filter is regenerated. But the engine power is restricted to
50 %.

Make sure that the regeneration process is shown on the display and that it proceeds until the display mes-
sage disappears.
KX060-05_067
1 1
KX060-05_067
1 1