Kuberg Ranger, Руководство пользователя, Страница: 16 / 38

Drivetrain
Your KUBERG Ranger features two traditional chains and sprockets and the central
double sprocket. It has a direct drive with no clutch and one reduction gear. Both chains
need to be lubricated and adjusted on a regular basis and before every ride. There
should be only a very little slack in the chain.
Adjusting chain tensions
Follow these steps to adjust the chain tension:
1
Make sure the on/off switch is in the OFF position.
2 Lift the motorcycle onto a block or stand so that both wheels are off the ground.
3
Using the Allen wrench #10 and the open wrench #24 loosen the rear axle nut.
4 Using the Allen wrench #4 (or Torx wrench #30) loosen and remove 3 bolts holding the
primary chain guard. Each bolt has its own spacer under the chain guard.
16 Ranger - OWNER‘S MANUAL
Setting power & torque modes
Follow these steps to limit the maximum power and torque on your KUBERG Ranger:
1
Turn off your motorcycle.
2 Press and hold the control button. The control
button is located on the right side of the
handlebar.
3 Turn on your motorcycle.
4 The motorcycle will beep one, two or three times
to indicate the desired power mode
One beep indicates Beginner Mode (low-
power), two beeps indicate Sport Mode
(medium-power) and three beeps indicate
Race Mode (maximum-power).
For example, if you want the medium power
mode, hold the control button for two beeps and release. The motorcycle will
confirm your selection with an audible “one”, “two” or “three” beep sound.
5 The power mode is now set. If you want to set a different power mode level, repeat
the process from step 1.
CAUTION!
Sport and Race modes should only be used by experienced riders!