KTR-STOP
®
L light-xxx A-xx-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
445123 EN
17 of 21
2
Please observe protection
note ISO 16016.
Drawn:
2020-09-25 Shg/Wie
Replacing:
KTR-N dated 2019-11-21
Verified:
2020-11-05 Shg
Replaced by:
In respect of environmental protection we would ask you to dispose of the products on termination of their service
life in accordance with the legal regulations and standards that apply, respectively.
•
Metal or brake pads, respectively
Brake pads and any other metal parts have to be cleaned and disposed of by scrap metal.
•
Gaskets
Gaskets can be disposed of by residual waste.
•
Sensors
Electrical components have to be treated as electrical waste.
•
Hydraulic oil
Hydraulic oils have to be collected in suitable tanks and disposed of by a waste disposal company.
Brake pads having a balance of pad height of less
than 2 mm have to be replaced by return.
Illustration 14: Replacement of brake pads
Replace the brake pads in both halves of the brake
simultaneously.
STOP
Parts released or falling down may cause injury to
persons or damage on the machine. Secure the
components before disassembly.
!
Never keep your fingers between brake disk and
brake when applying the brake in order to prevent
serious injuries of your hands. Before every main-
tenance operation please make sure that the brake
is fully secured against activating.
•
Disassemble the pad retainers (component 1.23) on one side mutually.
•
Remove the two pad retainers (component 2.3) on one side mutually.
•
Replace the brake pads that have worn off by pushing only the pad out of respectively into the plate.
•
Hand-tighten the pad retainers (component 1.23) mutually by each 5 hexagon screws (component 1.24) first.
Tighten the screws at the tightening torque T
A
= 302 Nm.
•
Hand-tighten the pad retainers (component 2.3) on both sides by each 2-off cap screws (component 2.4) first.
Tighten the screws at the tightening torque T
A
= 36 Nm.
•
Repeat chapter 2.4
Setting/re-setting of the brake
•
Make sure that the brake disk can rotate freely while not touching the brake pads or the housing.
Please note chapter 2 Assembly of the brake.
•
Before you reactivate the brake, observe chapter 2.3
Start-up of the brake
.
4
Assembly
4.12 Disposal
5
Maintenance
5.1 Replacement of brake pads
