DATAFLEX
®
42/1000
Torque Measuring Shaft
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
49016 EN
6 of 21
2
Please observe protection
note ISO 16016.
Drawn:
2017-01-02 Shg/Koe
Replaced for:
KTR-N dated 2015-04-13
Verified:
2017-01-02 Shg
Replaced by:
You may only assemble, operate and maintain the measuring shaft if you
have carefully read through the assembly instructions and understood them
had technical training
are authorized by your company
The measuring shaft may only be used in accordance with the technical data (see chapter 1). Unauthorized modi-
fications on the measuring shaft are not admissible. We will not assume liability for any damage that may arise. In
the interest of further development we reserve the right for technical modifications.
The
DATAFLEX
®
torque measuring shaft
described in here corresponds to the technical status at the time of
printing of these operating/assembly instructions.
The
RADEX
®
-N
couplings are supplied in preserved condition. Both
DATAFLEX
®
and
RADEX
®
-N
can be stored
at a dry and covered place for 6 - 9 months.
!
Humid storage rooms are not suitable.
Please make sure that condensation is not generated. The best relative air humidity is less
than 65 %.
!
In order to avoid any injuries and any kind of damage please always make use of proper
lifting equipment.
The couplings are packed differently each depending on size, number and kind of transport. Unless otherwise
contractually agreed, packaging will follow the in-house packaging specifications of KTR.
2
Advice
2.4 Intended use
3
Storage, transport and packaging
3.1 Storage
3.2 Transport and packaging
