KSP N305-150, Инструкция по эксплуатации и техническому обслуживанию, Страница: 14 / 42

22
For correct use and the safety of the Operator and the User, all screws, bolts and nuts must be
tightened to the correct tightening torque.
To this aim, personnel assigned to assembly, both for initial use and following disassembly for
transport or repair, must use a calibrated torque spanner and tighten the components according to
the tightening torque listed below.
Where the torque is indicated in the drawing, apply the indicated value.
If ‘coupling’ is indicated, tighten the nut until it comes into contact with the surface and there is no
axial clearance.
Where no indication is provided, manually tighten until it is fully secured.
The component indicated by ‘standard anti‐crush corner’, is available on request.
DEWERT
LINAK
23
M12x35 Bolt (1)
Castor D75 Swivel
Anti-Crush Corner for Base
Tubular Base 1 Assembly
M10x30 Bolt (1)
Boom Bushing 2
Boom Assembly
Grade 10.9 M10x55 Coupling
Bolt (1)
M10x75 Bolt (2)
Tightening Torque 30 Nm
Upright Assembly
Rod to Adjust Width of Assembled
Base
M 10x25 Screw SO 7380
2 x D8 Washers
1 x D10x30 Washer
M12x70 Bolt (1)
Tightening Torque 40 Nm
M10x45
Coupling Bolt (1)
Spreader Bar Pin
Spreader Bar Assembly
Grade 10.9 M10x55 Coupling
Bolt (1)
Dual Locking Castor
D100 Swivel
M10x75 Bolt (1)
Tightening Torque 43 Nm
Base Tubular Pin
Beam Assembly
D20 Shaft Seeger Ring
Models of the 300 series
104 105