13
5. WET AND DRY VACUUM
- Perform the operations described in par. 3
- Insert the flexible hose’s plug (21) (Fig. 2) in the socket (10) and make sure it’s properly fitted by
pulling slightly at it.
- Fit the desired vacuum accessory:
The white button (52) (Fig. 4), located on the steam hose handle, allows you to turn on / off the engine
and select the suction power between three different possible settings. The commutation between
the different available settings is shown on the display (“SELECTION PANEL”). To turn on the vacuum,
you should press and quickly release the white button, to increase its regulation, you should press
the white button continuously: medium, maximum regulations will be selected and again minimum /
medium / maximum, release the button when the display shows the desired regulation. At any time,
you can deactivate the suction with pressure / quick release of the white button. With the engine off,
pressing the vacuum, the engine will restart from the last selected regulation; this memory is cleared
once turning off the steam cleaner.
The vacuum cleaner can only work if the basket is in its position and containing the minimum water
level; otherwise, the signalling “WASTE BUCKET EMPTY” will appear on the display and it will
be impossible to use the function until water is put inside to ensure a minimum level of filtration.
When the dirt in the bucket is above the maximum level, the message “FULL WASTE BUCKET” is
displayed, the visual/ light signal will remain active until the removal of the alarm condition, while the
buzzer remains active for only 5 seconds. Restored the proper level of water in the waste bucket, if
you push the vacuum button again, the vacuum engine turns on. If, during engine functioning, the
water level in the basket reaches the maximum level, the alarm intervenes again and the engine
stops. Restore the proper water level in the waste bucket and turn on the engine.
Caution: It is of essential importance the use of anti-foam product recommended by the
manufacturer to prevent its formation in the waste bucket. The manufacturer assumes no
responsibility for damages resulting from failure to comply with this requirement and / or use
of products other than those recommended.
5.1 DUST RETENTION IN WATER
The Mod. Professional KGV7000 makes use of a patented wet retention system of dirt which has
been collected in the waste bucket (20) (Fig. 5). In the tank a water whirlpool captures the finest dry
particles, while the larger ones are retained by a stainless steel mesh filter. This system allows fresh
air to be released, with holding the vacuumed dust, pollen and mites, which are later eliminated by
simply emptying and cleaning the waste bucket.
6. STEAM CLEANING
- Perform the preparatory operations described in par. 3
- Insert the flexible hose’s plug (21) in the socket (10) (Fig. 2) and make sure it’s properly fitted by
pulling slightly at it.
- Fit the desired steam cleaning accessory (directly to the flexible hose and/or to the extension
hoses).
The steam control is made possible through the constant pressure made on the red button (51) (Fig.
4.1) located on the pistol grip; steam activation, takes place after a quick press of the button used;
the display shows the minimum steam regulation. To increase the amount of steam, push and hold
Содержание KGV7000
Страница 2: ......
Страница 3: ...Fig 1 1 Fig 13 Fig 1 2 Fig 2 Fig 5 Fig 3 ...
Страница 4: ...Fig Fig 4 Fig 4 1 Fig 4 2 51 51 Fig 7 Fig 8 Fig 9 ...
Страница 5: ...4 Fig 10 Fig 11 Fig 12 ...
