OPERATION
4
21
OPTISENS IND 1000
www.krohne.com
12/2016 - 4001969202 - MA OPTISENS IND 1000 R02 en
B1,sim.process inp.A
B2,sim.process inp.B
B4, actual values
B6, information
4.2.3 Menu C, setup
Level
Designation / function
Settings / descriptions
B1.1
B1.1
B1.1
B1.1
temperature
In this menu the temperature can be simulated.
B1.2
B1.2
B1.2
B1.2
spec. conductivitiy
In this menu the conductivity can be simulated.
B1.3
B1.3
B1.3
B1.3
spec. resistance
In this menu the resistance can be simulated.
Level
Designation / function
Settings / descriptions
This menu groups several functions which allow to display the corresponding actual reading. The shown measurements
are depending on the device configuration.
B4.2
B4.2
B4.2
B4.2
process input A
In this menu the measurements from process input A can be read.
B4.3
B4.3
B4.3
B4.3
process input B
In this menu the measurements from process input B can be read.
For 2 channel version only.
Level
Designation / function
Settings / descriptions
This menu groups several other menus which contain device specific information. The build-up of the display is the
same for all menus:
B6.1
B6.1
B6.1
B6.1
C number
Identifies the types of electronics, is also located on the converter
nameplate.
B6.2
B6.2
B6.2
B6.2
process input A
Gives information about the electronical part of process input A.
B6.3
B6.3
B6.3
B6.3
process input B
Gives information about the electronical part of process input B.
For 2 channel version only.
B6.4
B6.4
B6.4
B6.4
SW.REV.MS
Gives information about the main software of the electronics.
B6.5
B6.5
B6.5
B6.5
SW.REV.VIS
Gives information about the user interface of the device.
B6.6
B6.6
B6.6
B6.6
Electronic Revision ER
Reference identification number, electronic revision and production date of
the device; includes all hardware and software changes.
INFORMATION!
The signal converter MAC 100 has a dual process input, A and B. Each process input has an own
submenu in this main menu. Process input A is always present, i.e. there is always a board in the
interface "Pos.A" in the connection area. The interface of process input B only has a board with
the dual channel signal converter. Be aware that the definition which kind of measurement a
process input can do is defined when ordering the device. The configuration cannot be changed
later.
INFORMATION!
Note that the appearance of some submenus depends on the hardware setting and the used
sensor(s).
