Kripsol KS Evo, Руководство пользователя

Страница: 15 / 52

15
ENGLISH
In triphase motors, the impeller (16) can be
unscrewed if the motors starts in the opposite
direction. Counter-rotation can even damage
the mechanical seal.
Start the motor for a few seconds and check
that the direction of rotation coincides with
that indicated by the arrow on the ventilator
cover. Should this not be the case, it is
absolutely necessary to advise the authorised
installer (invert the phase connection).
6.4.
Check that the motor does not exceed the
amperage indicated on the nameplate rating
(36) (fig. 6, page 50); otherwise, regulate using
the header valve.
7. MAINTENANCE/CONSERVATION
Before touching, disconnect the electricity
supply.
7.1.
Regularly check and clean the motor filter (6)
(page 50).
To remove the pre-filter, place the selection
valve, and all other valves, in the “off” position.
Loosen the cover (2) of the pump casing,
remove the basket (6) and clean it under
running water; “do not strike” to avoid its
deterioration. To re-place the pre-filter (6),
introduce it gently, until it is in its original
position.
Correctly place the seal (3) of the cover (2) and
grease with vaseline.
The transparente cover (2) must be cleaned
with water and neutral soap; “do not use
detergents”. Do not place the filter (6) in
chemicals.
Please remember that changes in position of
the selection valve will be made at all times
with the motor switched off.
7.2.
If the pump is switched off for long periods
of time, should there be a danger of frost,
the pump casing (7) should be emptied, by
loosening the two emptying outlets (10) along
with their O-ring seals (8).
Before starting the pump, replace the outlets
(10) and their O-ring seals (8).
Fill the pump chamber with water and check
with a screwdriver that the motor is not
jammed. If the shaft has seized up, call a
qualified technician.
In the event of the motor flooding, do not try
to start it; call an electrician to dismount the
motor in order to dry it.
ATTENTION
ATTENTION
ATTENTION