KREMLIN REXSON
4
Manual : 574.331.112
PRESSURE HAZARDS
Current legislation requires that an
air relief
shut off valve is mounted on the supply circuit of the
pump motor to let air off when closing the supply circuit. Without this precaution, the motor residual
air of the motor may let the pump beat and cause a serious injury.
Please ensure that, a
material drain valve
is mounted on the material circuit to drain it (after
shutting down air to the motor and the pressure relief) before any servicing on the equipment. These
valves must be closed for air and opened for product when processing.
HIGH PRESSURE INJECTION HAZARDS
When working with high pressure equipment, special care is required. Fluid leaks can occur. Then
there are injection risks in exposed parts of body that may cause severe injuries or amputations :
Medical care must be handled immediately if product is injected under the skin or in other
parts of the body (eyes, fingers).
Never point the spray gun at any one. Never try to stop the spray with your hands or fingers
nor with rags or similars.
Follow the shut down procedure and always depressurize air and fluid circuits
before
carrying out any servicing on the gun (cleaning, checking, maintenance of the material or
cleaning of the gun nozzles).
For the guns equipped with a safety device, always lock the trigger when you do not start the
gun.
FIRE - EXPLOSION - SPARKS - STATIC ELECTRICITY HAZARDS
A poor earth connection, inadequate ventilation, sparks or static electricity can cause an explosion
or fire. to avoid these risks when using or servicing KREMLIN REXSON equipment, the following
safety procedures must be followed :
ensure a good earth connection and ground the parts to be handled i.e. solvents, materials,
components and equipment,
ensure adequate ventilation,
keep working area clean and free from waste solvents, chemicals, or solid waste i.e. rags,
paper and empty chemicals drums,
never use electrical switches / power if in an atmosphere of volatile solvent vapour,
stop working immediately in case of electrical arcs,
never store chemicals and solvents in the working area.
TOXIC PRODUCT HAZARDS
Toxic products or vapours can cause severe injury not only though contact with the body, but also if
the products are ingested or inhaled. It is imperative :
to know the material products and their risks,
notified or hazardous materials must be stored in accordance with the regulations,
the material must be stored in an appropriate container, never place materials in a container
where there is a risk o spillage or leakage,
a procedure must be applied for the safe disposal of waste material. It must comply with all
prevailing regulations and legislations of the country where the equipment is to be used,
protective clothing should always be worn in compliance with the material manufacturers'
recommendations,
depending on the application and chemical safety instructions, safety glasses, hearing
protective earplug, gloves, foot wear, protective masks and possible breathing equipment
should be worn to comply with the regulations
(Refer to chapter "Safety equipment of KREMLIN selection guide).
