Connecting Your SP-11D Digital Video Processor
9
6
Connecting Your SP-11D Digital Video Processor
You can use your
SP-11D
to convert composite video, s-Video, component video
(YUV or RGB/S), or SDI signals to composite video, s-Video, component video
(YUV, RGsB, RGBS, RGBHV) and
1
SDI. The processing can be evaluated on a
“Before/after” split-screen, as the example in
Figure 4
illustrates.
To connect the
SP-11D
Digital Video Processor
, do the following
2
1. Connect the following sources to the
SP-11D
:
:
The composite video source (for example, a VCR) to the CV INPUT
BNC connector
The s-Video source (for example, an S-VHS) to the Y/C INPUT 4-pin
connector
The SDI source (for example, a digital video player) to the SDI
INPUT BNC connector
2. Connect the component video INPUTS BNC connectors, G/Y, B/B-Y, and
R/R-Y to either a YUV or an RGB video source, as follows:
A Betacam VCR source to G/Y, R/R-Y, and B/B-Y,
or
A camera (RGBS) source to G/Y, R/R-Y, B/B-Y and SYNC
3. Connect the following acceptors to the
SP-11D
:
The SPLITTER OUTPUT BNC connector to a composite video
display
The Y/C OUTPUT 4-pin connector to an s-Video display
The CV OUTPUT BNC connector to a composite video display
The five BNC OUTPUTS connectors: G/Y, B/B-Y, R/R-Y, Vs/Cs, and
Hs/Cs to a video acceptor (for example, a plasma display)
The two SDI OUTPUT BNC connectors to two serial digital video
acceptors (for example, two displays: SDI 1 and SDI 2)
4. Connect the LOOP BNC connector to the next
SP-11D
Genlocked unit (if
required) and release the Term button for looping
3
5. Connect a Genlock source to the SYNC BNC connector.
.
6. Connect a PC or other controller, if required (see section
6.1
).
7. Set the DIP-switches (see section
6.2
).
8. Connect the power cord
4
(not illustrated in
Figure 4
).
1 All output formats are always available. However, when only one output is required, connect that output of the SP-11D, and
leave the other outputs unconnected
2 Switch OFF the power on each device before connecting it to your SP-11D. After connecting your SP-11D, switch on its
power and then switch on the power on each device
3 Pushed in terminates the input. Release when the input extends to another unit
4 We recommend that you use only the power cord that is supplied with this machine
