![background image](http://html.mh-extra.com/html/kramer/kn-dsp100/kn-dsp100_user-manual_2002073007.webp)
Kramer Electronics Ltd.
KN-DSP100
– Installing KN-DSP100 in a Rack
5
Installing KN-DSP100 in a Rack
This section provides instructions for rack mounting the
KN-DSP100
. Before installing in a
rack, verify that the environment is within the recommended range:
•
Operation temperature
– 0
to 40
C (32 to 104
F).
•
Storage temperature
– -40
to +70
C (-40 to +158
F).
•
Humidity
– 10% to 90%, RHL non-condensing.
When installing on a 19" rack, avoid hazards by taking care that:
▪
It is located within recommended environmental conditions. Operating ambient
temperature of a closed or multi-unit rack assembly may exceed ambient room
temperature.
▪
Once rack mounted, there is enough air flow around
KN-DSP100
.
▪
The
KN-DSP100
is placed upright in the correct horizontal position.
▪
You do not overload the circuit(s). When connecting the
KN-DSP100
to the
supply circuit, overloading the circuits may have a detrimental effect on
overcurrent protection and supply wiring. Refer to the appropriate nameplate
ratings for information. For example, for fuse replacement, see the value printed
on the product label.
▪
The
KN-DSP100
is earthed (grounded) and connected only to an electricity
socket with grounding. Pay particular attention when electricity is supplied
indirectly (for example, when the power cord is not plugged directly into the wall
socket but to an extension cable or power strip). Use only the supplied power
cord.
To rack-mount the KN-DSP100:
1. Attach both ear brackets to the
KN-DSP100
:
Remove the screws from each side of the
KN-DSP100
, and replace them through the ear
brackets.
2. Place the ears of the
KN-DSP100
against the rack
rails and insert the appropriate screws (not
provided) through each of the holes in the rack
ears.
▪
Detachable rack ears can be removed for desktop use.
▪
Always mount the
KN-DSP100
in the rack before connecting any cables or
power.