![background image](http://html.mh-extra.com/html/kramer/kn-dsp100/kn-dsp100_user-manual_2002073009.webp)
Kramer Electronics Ltd.
KN-DSP100
– Connecting KN-DSP100 via the Ethernet Port
7
Connecting KN-DSP100 via the
Ethernet Port
You can connect to the
KN-DSP100
via Ethernet using either of the following methods:
•
Connecting the Ethernet Port Directly to a PC
•
Connecting the Ethernet Port via a Network Hub or Switch
If you want to connect via a router and your IT system is based on IPv6, speak to your IT
department for specific installation instructions.
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
KN-DSP100
directly to the Ethernet port on your PC
using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
KN-DSP100
with the factory
configured default IP address.
After connecting the
KN-DSP100
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and click
Change
settings of this connection
.
The Local Area Connection Properties window for the selected network adapter appears
as shown in
Figure 3: Local Area Connection Properties Window