FC-10ETH –
Configuring the FC-10ETH Ethernet Controller
7
4
Configuring the FC-10ETH Ethernet
Controller
This section describes:
•
How to connect the
FC-10ETH
for configuration, via its ETHERNET port (see
U
Section 4.1
U
)
•
How to install and run the Configuration Manager software (see
U
Section 4.2
U
)
•
The Configuration Manager Window features (see
U
Section 4.2.1
U
)
4.1
Operating via the ETHERNET
You can connect to the
FC-10ETH
via Ethernet using either of the following
methods:
•
Direct connection to the PC using a crossover cable (see
U
Section 4.1.1
U
)
•
Connection via a network hub, switch, or router, using a straight-through cable
(see
U
Section 4.1.2
U
)
4.1.1
18B
Connecting the ETHERNET Port Directly to a PC (Crossover Cable)
You can connect the Ethernet port of the
FC-10ETH
to the Ethernet port on your
PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
FC-10ETH
with the factory configured default IP address.
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select
Properties
.
3. Right-click Local Area Connection Properties.
4. Select
Properties
.
The Local Area Connection Properties window appears.
i
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
