6
FC-10ETH - Overview
#
Feature
Function
1
12V DC
+12V DC connector for powering the unit
2
RS-232 COM 1
Port
Connects to the RS-232 9-pin D-sub port on the Kramer (or
other) device 1 or PC
3
ETHERNET
Port
Connects to your LAN
4
RS-232 COM 2
Port
Connects to the RS-232 9-pin D-sub port on a Kramer (or
other) device 2 or PC
A Kramer device can be connected to either the RS-232 COM 2
port, or to the RS-485 terminal block port (but not to both)
5
RS-485
Terminal
Block Port
Connects to the RS-485 port on a Kramer (or other) device
A Kramer device can be connected to either the RS-232 COM 2
port, or to the RS-485 terminal block port (but not to both)
PIN A connects to the “A” (+) PIN; PIN B connects to the “B”
(–) PIN (and PIN G connects to the “G (Ground)” PIN, if
necessary)
The connection to G is usually not necessary for RS-485
6
STATUS COM 1
LEDs Lit when a signal is transmitted or received from port 1
(mostly used for troubleshooting)
7
STATUS COM 2
LEDs Lit when a signal is transmitted or received from port 2
(mostly used for troubleshooting)
8
ON
LED
Lit when receiving power
9
RESET
Button
Press to reset the machine
Turns the machine off and on again while retaining its definitions
(identical to disconnecting the power adapter and then connecting
it again)
10
RS-485 TERM.
Button Press for BUS termination:
Set to OFF if the RS-485 terminal block port is not connected
Set to ON if the RS-485 terminal block port is connected
11
FACTORY RESET
Button
Press to reset to factory default definitions
First disconnect the power adapter and then connect it again while
pressing the FACTORY RESET button. The unit will power up and
load its memory with the factory default definitions
12
PROG
Switch
Switch ON to upgrade firmware
13
CONFIG
Switch
Not used, set to OFF
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
