FC-10ETH –
Controlling Machines via the Ethernet using the FC-10ETH
17
Unit
(B)
is configured to the Active mode.
6. Connect units
(A)
and
(B)
to your network or Ethernet router, as illustrated in
U
Figure 9
U
.
7. Connect up to two machines, that is, the RS-232:
COM 1 port of the
FC-10ETH (A)
to the RS-232 port of your machine 1
(for example, a Kramer machine) via a null-modem adapter
COM 2 port of the
FC-10ETH (A)
to the RS-232 port of your machine 2
(for example, a Kramer machine) via a null modem adapter
(alternatively, you can connect the RS-485 port of unit
(A)
to the RS-485
port of your Kramer machine).
To connect the RS-485 port, connect PIN A to the “A” (+) PIN and PIN B to the
“B” (–) PIN
8. Connect up to two serial controllers to unit
(B)
:
Connect the RS-485 terminal block of the serial controller (1) to the
RS-485 terminal block port on the
FC-10ETH (B)
Alternatively, you can connect an RS-232 output terminal block of the serial
controller to the RS-232 COM 2 port of the FC-10ETH
Connect the RS-232 port of the serial controller (2) to the RS-232 COM
1 port on the
FC-10ETH (B)
9. Connect the power on each of the devices as follows:
The Kramer machines
FC-10ETH (A)
Connect the 12V DC power adapter to the power socket and connect the adapter
to the mains electricity
FC-10ETH (B)
Connect the 12V DC power adapter to the power socket and connect the adapter
to the mains electricity
The serial controllers
A connection will be established after the user sends the first
command from the serial controller to the serial controlled device.
i
i
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
