FC-10ETH –
Configuring the FC-10ETH Ethernet Controller
11
#
Feature
Function
1
M
en
u bar
File
Exit
: closes the Configuration Manager application
Action
Search Board
: seeks the
FC-10ETH
devices that connect to the PC
via the ETHERNET port, and displays them and their corresponding
settings
Config
: adjusts the
FC-10ETH
according to the displayed data
Set MAC
For factory use only
Click the Password command to enter the password
About
Displays software development information, including the software
version
2
Device List
Displays the MAC Addresses for the
FC-10ETH
devices, connected
via the selected port (LAN or COM)
3
CHA
NNE
L 1
/ CHA
NNE
L
2
Local Port
An address (for the local ports COM 1 and COM 2) on the
FC-10ETH
device that is currently being configured, which provides
a direct route from another Ethernet point application
4
Active Mode
Check Box
When selected, activates the Active mode (see
U
Section 4.3.2
U
)
When cleared, activates the Passive mode (see
U
Section 4.3.1
U
)
5
Serial
Settings
Area
Speed
list: click the appropriate baud speed (1200, 2400, 4800,
9600, 19200, 38400, 57600 or 115200)
The configuration baud is factory preset, and fixed, at 9600
Parity
list: click the required parity (None, Odd, Even, Mark or
Space)
6
Destination
Settings
Area
Destin.
IP
: a 32-binary digit number that identifies the destination
FC-10ETH
device in the Ethernet or Internet
Port
: a pre-assigned address of the destination
FC-10ETH
device
that provides a direct route to its Transport layer
The Destination Settings area is active only when the Active Mode check
box is selected
7
Progress Bar
Shows the progress
8
Status Bar
Shows the status
9
Exit Button
Closes the Configuration Manager application
10 Action Buttons
Search
: seeks the
FC-10ETH
devices that connect to the PC via the
ETHERNET port, and displays them and their corresponding
settings
Config
: adjusts the
FC-10ETH
according to the displayed data
11 Device Network
Settings Area
DHCP Mode
Check Box: When selected, automatically configures
the
FC-10ETH
to obtain an IP address from the network
administrator via the Dynamic Host Configuration Protocol (DHCP).
When cleared, manual configuration of the
FC-10ETH
is required to
obtain an IP address (Static IP)
IP Address
:
A 32-binary digit number obtained from your Network
Administrator that identifies the
FC-10ETH
device that is currently
being configured in the Ethernet or Internet
Subnet
: A 32-binary digit number obtained from your Network
Administrator, which combined with the IP Address, identifies which
network your
FC-10ETH
device is on
Gateway
: A network position serving as an entry to another network
or to the Internet
(only relevant in the Active Routing mode)
12 Version
Displays the firmware version
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
