16
FC-10ETH - Controlling Machines via the Ethernet using the FC-10ETH
5.1.2 Setting an Ethernet Connection
If the control application can directly connect to the Ethernet driver, select the host
IP and port number according to your
FC-10ETH
configuration, as illustrated in
Figure 8
.
Figure 8: The Port Window – Selecting a Remote Connection
5.2
Controlling a Kramer Machine via a Serial Controller
To control a Kramer machine via serial controllers (in the Active routing mode), as
illustrated in the example in
Figure 9
, do the following:
1. Connect the
FC-10ETH (A)
12V DC power adapter to the power socket and
connect the adapter to the mains electricity.
2. Configure the
FC-10ETH (A)
to the Passive routing mode (see
Section
4.3.1
3. Disconnect unit
(A)
.
).
Unit
(A)
is configured to the Passive mode.
4. Connect the
FC-10ETH (B)
12V DC power adapter to the power socket and
connect the adapter to the mains electricity.
5. Configure the
FC-10ETH (B)
to the Active routing mode (see
Section 4.3.2
Destin. IP set in unit
(B)
is identical to the IP address on unit
(A)
)
and then Disconnect unit
(B)
. Make sure that the:
Destination Settings Area for CHANNEL 1 and CHANNEL 2 of unit
(B)
are set to be identical to the Port numbers in the Local Ports on
CHANNEL 1 and CHANNEL 2 or according to the connections we want
to establish with unit
(A)
i
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
