kozy heat Nicollet NCL-195, Инструкция по установке и эксплуатации

Страница: 18 / 44

VENTING
(HORIZONTAL)
PAGE 17
MINIMUM HORIZONTAL VENTING
EXHAUST DAMPER POSITION
(LP GAS HORIZONTAL VENT CONFIGURATION)
TERMINATION
CAP
This fireplace is shipped with the exhaust damper in the „closed‟ (approx. 1/2” (13 mm) open) position.
If using LP gas and incorporating a horizontal vent configuration, the exhaust damper may need to be
adjusted to a more open position.
Open damper far enough to prevent flame from burning dirty, which results in soot accumulation on glass.
TO ADJUST: Loosen wing nuts securing damper. Slide damper toward front of fireplace. Retighten wing
nuts to secure position.
MAXIMUM HORIZONTAL VENTING
90-DEGREE ELBOW
Wing Nuts
MAXIMUM 20 ft.
(6.096 m)
TERMINATION
CAP
90-DEGREE ELBOW
NOTE: Horizontal sections require 1/4” (6 mm) rise for every 12” (305 mm) of travel.
CAUTION: This gas appliance must not be connected to or joined with any other chimney flue serving another appliance.
IMPORTANT: THE HORIZONTAL VENT HEAT SHIELD MUST BE INSTALLED WHEN USING A 90-DEGREE ELBOW TO
HORIZONTALLY POSITION VENT SYSTEM.
IMPORTANT: KOZY HEAT WALL PASS-THRU, PART #800-WPT (4-1/2” (114 mm) - 6-1/2” (165 mm) ) WALL THICKNESS OR
#800-WPT2 (6-1/2” (165 mm) - 12-1/2” (318 mm) ), MUST BE USED ON ALL HORIZONTAL VENT RUNS.