26
FIREPLACE SETUP
8.5 Control Board Removal
and Installation
WARNING: If burner and/or pilot have been burning,
use appropriate protection to avoid burns or damage
to personal property before removing any components.
DO NOT OPERATE THIS APPLIANCE WITHOUT THE SEALING
GASKET (LOCATED UNDER THE CONTROL BOARD) IN PLACE.
IF GASKETING IS DAMAGED, IT MUST BE REPLACED.
CAUTION: Check all connections for leaks with soapy water,
whether field or factory made.
8.5.1 Control Board Removal
1. Disconnect electrical power.
2. Locate the manual valve installed by your qualified service
technician.
3. Turn the manual valve clockwise to the OFF position.
4. Remove the safety barrier and glass frame assembly.
5. Remove glass media and media tray.
6. Remove (1) screw securing burner cover located at the back
wall of the firebox.
7. Lift the right side of the burner up to release from burner
orifice.
8. Remove halogen bulbs.
9. Remove and save (7) screws securing control board.
10. Lift control board out of firebox, being careful not to damage
sealing gasket lying underneath.
8.5.2 Control Board Installation
1. Place the control board in firebox, aligning the holes in board
with mounting studs at the bottom of the firebox.
VERIFY SEALING GASKET IS IN PLACE.
2. Secure the control board with screws previously removed.
3. Reinstall halogen bulbs.
4. Reinstall burner cover, aligning holes in cover to
corresponding holes on burner. Secure with (7) screws
previously removed.
5. Reinstall glass media, being careful not to block pilot.
6. Reconnect all wiring harnesses to gas valve. Plug all
components into electrical outlet.
7. Reinstall glass assembly.
8. Turn the manual valve counterclockwise to the ON position.
9. Reconnect electrical power.
10. Verify proper glass media placement, operation of fireplace,
and any electrical components.
Figure 8.4, Control Board Removal and Installation
