24
FIREPLACE SETUP
8.0 FIREPLACE SETUP
8.1 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly, should
be done by a licensed or qualified service person.
8.1.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1. Locate the spring-loaded latch securing the glass assembly
at the bottom of the firebox.
2. Pull the spring-loaded latch out and down to release the
bottom of the glass assembly.
3. Life glass assembly up and off of the (2) tabs located at the
top of the firebox.
8.1.2 Install Glass Frame Assembly
1. Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2. Pull the spring-loaded latch out and up to secure the bottom
of glass to the bottom of the fireplace.
8.2 Light Kit
ATTENTION: If converting to LP (propane) gas, complete the
conversion before installing any media. Follow instructions
included with the gas conversion kit.
CAUTION: Disconnect all electric power from the fireplace
insert before performing any of these tasks.
NOTE: To avoid damage and prolong the life of the halogen
bulbs, never touch with bare hands. Always use a soft cloth
when handling.
1. Remove (1) screw securing burner cover located at the back
wall of the firebox.
2. Lift the right side of the burner up to release from burner
orifice. Remove burner.
3. Install (4) halogen bulbs (included in components packet)
into lamp bases.
4. Reinstall burner cover, securing with (1) screw previously
removed.
8.3 Glass Media Installation
WARNING: DO NOT BLOCK PILOT WITH GLASS MEDIA. A
BLOCKED PILOT MAY CAUSE DELAYED IGNITION.
IMPORTANT: Use only #104 Series Glass Media (4 lbs. / 1.8
kg) in this fireplace. DO NOT substitute materials or use more
than specified.
1. Install 4 lbs. (1.8 kg) of glass beads onto burner assembly
and pilot shield.
2. Verify the glass media is one layer deep across the firebox.
Do not block the pilot assembly.
3. Save any unused media for later use.
Figure 8.1, Lamp Base Location
Figure 8.2, Pilot Assembly Location
DO NOT BLOCK
THIS AREA
