kozy heat MINNETONKA 55345, Инструкция по установке и эксплуатации

Страница: 18 / 39

Page 17
INSTALLATION INSTRUCTIONS
THE FOLLOWING COMPONENTS MUST BE REMOVED FROM THE
FIREPLACE PRIOR TO INSTALLATION OF THIS FAN. REFER TO
THE CORRESPONDING PAGES IN THIS INSTALLATION MANUAL
FOR ASSISTANCE IF NECESSARY.
1. Upper hood, upper louver & lower grill, if installed. Refer to
page #24 if necessary.
2. Glass assembly.
Note: Millivolt board has been removed for clarity. It is not
necessary to remove the millivolt board to install this
optional fan kit.
INSTALL THE FANS:
1. Slide the left and right fans through the lower grill opening (left
side of the valve) and push all the way to the fireplace back.
2. Slide the left fan assembly to the left until it stops and slide the
right fan assembly to the right until it stops. NOTE: The fans
will be behind the legs. Figure 15A.
NOTE: Each fan bracket is held in position by a magnetic strip
attached to the bottom of each bracket.The mounting studs are
not used when installing this fan assembly.
3. Connect the fan wiring by inserting the red connectors on the
right fan wires onto the terminals on the left fan assembly. It
does not matter which connector is on each terminal. Figure
15B.
44. Remove the (2) screws securing the removable access panel
(with electrical box & romex connector installed) from the right
side of the fireplace.
5. Insert 115V wiring (with ground) through the romex connector
and wire to the speed control / receptacle assembly matching
the black (hot) white (neutral) and green (ground) wire to the
corresponding wire on the speed control / receptacle assembly.
NOTE: (3) wire nuts are included in the fireplace components
packet.
6. Secure the speed control / receptacle assembly into the
electrical box with the (2) screws provided.
7. Replace the electrical access panel and secure with the (2)
screws removed.
8. Place the thermostatic control switch on the bottom of the
firebox.
9. Plug cord into receptacle in the electrical box.
10. Turn on/off speed control counter-clockwise until it ‘clicks’.
This is the ‘OFF’ position.
11. Turn the speed control ‘ON’ by turning the knob clockwise past
the ‘click’ - this is the highest setting.
12. Replace the glass assembly.
13. Replace the lower grill, upper louver & upper hood. Refer to
page #24 if necessary.
NOTE: The fan will not operate unless the speed control has been turned
‘ON’ and sufficient heat has been applied to the temperature control
switch. The fan will turn ‘ON’ and ‘OFF’ automatically when the fireplace
heats and cools. Adjust fan to desired speed while it is running.
Figure 15A
Connect fan
wiring
Figure 15B
Figure 15C
TEMPERATURE CONTROL SWITCH POSITION: Prior to adjusting the
temperature control switch, unplug the 3-prong plug on the fan cord from the
receptacle. Adjust the position of the temperature control switch to a warmer
location under the firebox to turn the fan ‘ON’ sooner or move it to a cooler
location under the firebox to turn the fan ‘ON’ later. The fan will turn on when
the sensor in the temperature control switch reaches 110
o F and will turn
‘OFF’ when the sensors reach 90
o
F. After adjustment, plug the 3-prong plug
on the fan cord into the receptacle.
NOTE: This appliance must be electrically grounded and connected in
accordance with local codes, or in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70-Current edition, or the Canadian
Electrical Code, CSA C22.1.
Slide to the left.
Slide to the right.
Speed Control /
receptacle assembly
Thermostatic
Control Switch