M. MODEL CSK-335 ONLY: THERMOSTAT - WALL SWITCH - REMOTE INSTALLATION
If desired, a thermostat (wireless style available), wall switch, or remote
control assembly may be used to turn the fireplace ‘OFF’ and ‘ON’. Only
ONE
of these may be installed. Follow instructions included with each
assembly.
OPTIONAL: Disconnect the ON/OFF rocker switch wires from the top &
bottom terminals on the back side of the gas valve. Refer to Figure Q-1,
page #28 of this manual.
NOTE: INSTALLATION OF A THERMOSTAT OR WALL SWITCH
SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER.
Run low-voltage (thermostat) wires from the terminals
on the gas valve to the desired location of the wall switch
or thermostat.
Attach the appropriate connector to each wall switch /
thermostat wire and connect to the top and bottom
terminals on the gas valve marked ‘TH’.
Follow instructions included with the remote control.
CAUTION: DO NOT CONNECT HIGH VOLTAGE (115V) WIRE TO THE GAS VALVE!
IMPORTANT:
The insulated cover included with the
remote control must be placed over the remote receiver
to protect it from overheating.
WALL SWITCH / THERMOSTAT USERS:
REMOTE CONTROL USERS:
IMPORTANT:
If the ON/OFF rocker switch wires
are not disconnected, the ON/OFF rocker switch
on the millivolt board must be in the ‘OFF’ position
for proper operation of any of these components.
If the rocker switch is ‘ON’, the fireplace burner will
operate until it is turned ‘OFF’ by the rocker switch.
A wall switch, thermostat, or remote control will not
turn the fireplace ‘OFF’ when it has been turned
‘ON’ by the rocker switch.
NOTE: The fireplace must be turned ‘ON’ and
‘OFF’ by the same method. For example: If the
fireplace is turned ‘ON’ by the remote control, it
must be turned ‘OFF’ by the remote control.
Thermostat Wiring Diagram
Figure M-1
Remote Control Wiring Diagram
Figure M-2
Page 18
