kozy heat CAMBRIDGE CMB-31, Инструкция по установке и эксплуатации

Страница: 9 / 34

Page 7
wiring to the pre-installed electrical box is desired, the wiring should be run prior to permanently setting the insert in place
and connecting the vent system.
NOTE: If this insert is being installed in the minimum opening dimensions, the wiring may need to be completed after the
fireplace insert is set in place.
The fan is equipped with a three-prong (grounding) plug attached to the end of the fan electrical cord for protection against
shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not remove the grounding
prong from the plug. Do not allow any excess fan ford to touch the fireplace.
NOTE: Code approved line voltage wiring 14 gauge or better must be used when wiring this assembly. Refer to your local
electrical codes for specific requirements in your area.
WARNING: This appliance is equipped with a three-prong (grounding) plug for protection against shock hazard and should
be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding
prong from this plug.
Figure D-1
INSTALLATION INSTRUCTIONS
1. Remove the (2) screws securing the removable access panel (with electrical box & romex connector installed) from the right
side of the fireplace.
2. Insert 115V wiring (with ground) through the romex connector and wire to the speed control / receptacle assembly matching
the black (hot) white (neutral) and green (ground) wire to the corresponding wire on the speed control / receptacle assembly.
NOTE: (3) wire nuts are included in the fireplace components packet.
3. Secure the speed control / receptacle assembly into the electrical box with the (2) screws provided.
This appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Codes, CSA C22.1.
MODEL #CMB-31-RF ONLY: FAN INSTALLATION INSTRUCTIONS
I
NSTALLATION OF THIS FAN WIRING SHOULD BE DONE ONLY BY A QUALIFIED INSTALLER
IMPORTANT: A fan assembly is pre-installed and wired to the RF gas valve in the CMB-31-RF models.