Page 4
WARNING:
CUTTING ANY SHEET-METAL PARTS OTHER THAN COMPONENTS LISTED IN THIS
SECTION, OF THE EXISTING FIREPLACE, IN WHICH THIS GAS FIREPLACE INSERT IS TO
BE INSTALLED, IS PROHIBITED.
1)
The refractory, glass doors, screen rails, screen mesh and log grates may be removed from the fireplace
before installing this gas fireplace insert.
2)
Any smoke shelves, shields and baffles may be removed if attached by mechanical fasteners.
3)
If necessary, remove the firebrick on the sides and back of the existing fireplace to obtain at least the
minimum opening requirements listed on page #2.
4)
The fireplace flue damper can be fully blocked open or removed for installation of this gas fireplace insert.
5)
ZERO CLEARANCE FIREPLACE INSTALLATIONS: The floor of the existing fireplace may be removed to
achieve minimum opening size requirements. If this method is used, the Kozy Heat Floor Protector kit,
Part #CMB-FLP, must be installed to protect any combustible flooring exposed.
6)
Remove the existing chimney cap from the chimney.
7)
Clean the chimney and inside of the fireplace to prevent creosote smell from entering the home.
8)
Place ‘THIS UNIT HAS BEEN MODIFIED’ label in the bottom of the firebox so it will be visible if this gas
fireplace insert is removed.
B. RUN THE GAS LINE
CAUTION:
Installation of the gas line must only be done by a qualified person in accordance
with local building codes.
IMPORTANT:
DO NOT RUN THE GAS LINE IN A MANNER THAT WOULD OBSTRUCT THE
OPERATION OF THE FAN OR FAN COMPONENTS.
This fireplace is equipped with a 3/8" flexible gas line connection 18" long.
CAUTION:
The manual shut off valve and millivolt board flexible gas line must not extend outside the insert
unit cavity. See the WARNING label affixed to the flexible gas line for additional installation
instructions and warnings.
1.
Run the gas line into the fireplace, preferably through the left or right gas line hole provided. A gas line
knock-out is also located in the outer bottom of the insert when running the gas line through the bottom.
See Figure B-1 on page #5.
NOTE:
If installing this insert into minimum opening dimensions, the gas line may need to be run after
the insert is in place due to space limitations.
If installing this gas fireplace insert into a factory-built fireplace and the factory-built fireplace
has no access holes(s) provided, an access hole of 1 ½" or less may be drilled through the
lower sides or bottom of the firebox in a proper workmanship like manner. This access hole
must be plugged with non-combustible insulation after the gas supply line has been installed.
IMPORTANT:
An accessible shut off valve (included with the unit) must be installed up stream from the
regulator.
Содержание CAMBRIDGE CMB-31
Страница 33: ...Page 31 Warranty Policy...
Страница 34: ...Page 32 Warranty Policy...
