Kozi 100 & Insert, Руководство пользователя

Страница: 17 / 24

Page 17
III. Maintenance
During operation, your heater produces a lot of “FLY” ash. The ash will deposit inside
the heaters’ air passages and must be removed on a regular basis. A medium size brush
is ideal for this purpose. Make sure the heater is cool and there are no embers present in
the burn pot, ashtray or combustion chamber. Also, make sure there is no power to the
unit by unplugging the power cord from the power source. Your heater can then be
cleaned in the following manner:
1. Pull and push the cleaning rod, which is located in the center, above the
door. This will remove the ash deposits on the heat exchanger tubes.
The removed ash will fall on the top heat shield, located in the burn
chamber.
2. Lift the top heat shield and remove it carefully as there may be a
significant amount of ash on it. Dump the ashes into the burn
chamber.
3. Brush the top heat shield clean and remove it from the heater.
4. Remove the burn pot and burn pot stand and clean them thoroughly.
5. Using a brush, clean the walls and floor of the burn chamber. Dump all
of the ash into the ashtray. Remove the ashtray and dispose off the
ashes in safe manner. If ashes are stored in a container, make sure the
lid is secure. DO NOT place the container on combustible surfaces.
6. Once a year, at the start of the heating season, clean the heater and all
of the venting pipes. Check for any blockage in the intake and exhaust
pipes.
7. Replace burn pot stand, burn pot and top heat shield to their original
positions.
8. Clean the glass with a mild glass cleaner.
9. Inspect condition of the door gasket periodically and replace as
necessary.
10. Open the right hand side panel and oil the circulation fan motor
bearings. Use a light oil such as sewing machine oil. The 2 oil ports
are located on the top of the motor, one near the end and one near the
fan housing. There may be a rubber plug in one or both of these oil
ports. This plug must be removed prior to oiling.