Kozi 100 & Insert, Руководство пользователя

Страница: 14 / 24

Page 14
Once this switch has been tripped, the control system will not allow any more fuel to
feed into the burn pot until it has been manually reset. DO NOT RESET THIS UNIT
UNTIL THE CAUSE HAS BEEN FOUND AND REPAIRED. Failure of this compo-
nent will result in a status light change. See “Troubleshooting” section for more details.
1.8 Pressure Switch.
The pressure switch is a safety device that senses whether or not the exhaust fan is
functioning properly. Failure of this component will also result in a status light change.
See “Troubleshooting” section for more details
2. Heater Operation
In order to use your stove, you should be familiar with the 4 controls of your heater: Fan
Speed, Feed Rate, Damper and Start button. These 4 controls will allow you to adjust
and operate your stove safely and efficiently. The location and method of adjustment for
each of these is described below.
2.1 Circulation Fan Speed Control
The fan speed control is located on the top center of
the control panel (see diagram). Turning this knob
counter-clockwise temporarily turns the circulation
fan off. Rotating clockwise decreases the speed of
the circulation fan from High to Low. It is NOT
recommended to leave this knob in the OFF
position. When left in the OFF position, the heater
becomes over heated and the control circuit
automatically overrides this switch and puts the
circulation fan on high speed.
2.2 Feed Control Knob
The feed control is a round knob located at the bottom of the control panel (see diagram).
Turning the knob in the counter-clockwise direction will turn the feed off. As the knob
is turned clockwise, the feed rate into the burn pot is increased, resulting in a bigger fire.
2.3 Damper Control
The damper control rod is located on the left side of the stove. This rod controls the
amount of air passing through the burn pot. By pushing the control rod in, you reduce
the amount of air passing through the burn pot. By pulling the rod out, you will increase
the amount of air passing through the burn pot.