Kozi 100 & Insert, Руководство пользователя

Страница: 15 / 24

Page 15
2.4 Start Button
The start button is located in the middle of the control panel (see diagram). Pushing the
start button is the first step in starting the heater. The heater will now run in manual
operation mode for 15 minutes. The heater will switch to the automatic mode only if the
heater reaches a preset temperature. If this temperature is not reached within 15 minutes
the unit will shut off. To allow the unit to run for another 15 minutes, simply press the
start button again.
2.5 Starting your Heater for the First Time
Once your heater is properly installed, complete the following steps to light it for the first
time:
1. Fill the hopper with pellet fuel.
2. Turn the feed control knob clockwise to high.
3. Press the start button. The exhaust and circulation fan should come on
and all 3 status lights should begin to blink.
4. Monitor the burn pot (located inside the burn chamber, see “Stove
Cross Section” diagram for exact location.). Once pellet fuel begins to
drop into the burn pot, turn the feed control knob to OFF, (counter
clockwise until it “clicks”) and allow the unit to stop running. Do not
light the pellet fuel at this time. If the unit stops and no fuel has been
fed into the burn pot, repeat steps 1 through 4.
You are now ready to light the stove for the first time.
2.6 Starting (lighting) your Heater
To start your heater, complete the follow steps:
1. Ensure there is adequate fuel in the hopper.
2. Turn the fuel feed knob to desired setting. (If in doubt, adjust to 12
o’clock setting)
3. Adjust damper to approximate setting. (If in doubt, pull open to
approximately 3/4" - 2 cm)
4. If equipped with electric start, proceed to step 9.
5. Open the burn chamber door and place a handful of fuel in the burn
pot. The burn pot should be approximately 1/4 full with wood pellets.
6. Pour lighter gel on pellets in the burn pot.
7. Ignite lighter gel with barbecue lighter and allow the pellets to catch
fire. DO NOT ATTEMPT TO IGNITE HOPPER FUEL ON FIRE.
8 Close the combustion chamber door.
9. Press the start button. The following should happen :
a. The exhaust fan will start.
b. The circulation fan will start at the fan speed control setting.