Basic Guide
23
Introduction
Front and rear panel
Connections
Playing
Editing
d. Apply distortion to the output
●
Press the [DISTORTION] key.
Each time you press the key, distortion will be turned
on/off.
When this is on ([DISTORTION] key LED lit), distortion
will be applied. This is effective when you wish to pro-
duce a hard\ harsh tone.
If distortion is turned on, use the MIXER knobs to adjust
the degree of distortion.
If you adjust FILTER “Cutoff” or “Resonance,” the char-
acter of the distortion will change.
e. Use keyboard playing dynamics to vary the volume
●
Press the SELECT [7] key, and then press the CURSOR
[
®
] key four times.
The LCD screen will show Page 09E: AMP “Vel Sense.”
Use the [+/YES] [–/NO] keys to set the value.
Positive (+)
values will cause the volume to increase as
you play more strongly.
Negative (–)
values will cause the volume to decrease as
you play more strongly.
f. Vary the volume by the keyboard location you play
●
From the “Vel Sense” screen, press the CURSOR[
®
]
key.
The LCD screen will show Page 09F: AMP “KBD Track.”
Use the [+/YES] [–/NO] keys to set the value.
Positive (+)
values will cause the volume to increase as
you play upward on the keyboard, and decrease as you
play downward on the keyboard.
Negative (–)
values will cause the volume to increase as
you play downward on the keyboard, and decrease as
you play upward on the keyboard.
7. Specify time-variant changes in volume
EG 2 produces time-variant changes in the AMP “Level.”
If you wish to use the front panel knobs to adjust the
EG 2 parameters, you must first use the SEQ EDIT
[SELECT] key to make the SEQ 1–3 LED’s go dark.
a. Adjust the speed at which the
sound
will attack\
trigger
●
Rotate the EG 2 [ATTACK] knob.
The LCD screen will show Page 11A: EG 2 “Attack.”
Rotating the knob toward the right (increasing the
value) will cause the sound to attack/ trigger more
slowly, and rotating it toward the left (decreasing the
value) will cause the sound to attack/ trigger instantly.
If rotating the knob does not produce an effect, make
sure that the AMP [EG 2/GATE] key LED is dark.
b. Adjust the speed at which the volume will decay
●
Rotate the EG 2 [DECAY] knob.
The LCD screen will show Page 11B: EG 2 “Decay.”
Rotating the knob toward the right (increasing the
value) will cause a longer decay time until the sustain is
reached.
c. Adjust the volume of the sustained sound
●
Rotate the EG 2 [SUSTAIN] knob.
The LCD screen will show Page 11C: EG 2 “Sustain.”
Rotating the knob toward the right (increasing the
value) will produce a louder volume during the sustain.
09E AMP
Vel Sense: +30
09F AMP
KBD Track: +25
time
Note on
Note off
Level
a: Attack Time
c: Sustain Level
b: Decay Time
d: Release Time
a
c
d
b
a
b
c
d
11A EG 2
Attack: 000
11B EG 2
Decay: 021
11C EG 2
Sustain: 090
