Kontron cPCI-MXS64, Техническое справочное руководство

Страница: 129 / 132

cPCI-MXS64 Technical Reference Manual
G-2
G.2 G
ENERATE AN
E
MERGENCY
F
LOPPY
D
ISKETTE
:
Use a system that has a 1.44 Mbytes floppy drive A.
1. Insert the Kontron Emergency Diskette in drive A:
2. Copy the two files WDISK.COM and EMERDISK.TEK to your hard drive (those files
are available from the driver’s CDROM).
3. Insert a DOS formatted floppy diskette in drive A:.
4. At the DOS prompt of your hard drive (same path of the two files WDISK.COM and
EMERDISK.TEK), type WDISK EMERDISK.TEK then press Enter key.
5. The program may display one of the following messages:
“Emergency Code transferred”
The emergency diskette has been successfully created. Take the appropriate
actions and restart from the step 4) when you see the following messages.
“Write to disk failure!”
Verify if your floppy diskette is write-protected.
“The file to program in flash was not found”
Be sure that EMERDISK.TEK file is in your current path.
“Unable to read the binary file”
or
“Unable to close the
opened file”
Possible floppy diskette corruption or bad data transfer between floppy disk
and host system.
“Unable to allocate a memory block of 256 Kbytes”
Not enough memory to run the WDISK program.