COMe-bEP7 Module User Guide
www.kontron.com
// 91
Sub-Screen
Second Level Sub
Further Sub-Screens/Description
or
COM1 Console
Redirection
Settings>
COM0 Console
Redirection
Settings>
or
COM1 Console
Redirection
Settings>
(continued)
Terminal Type>
Emulation:
ANSI: Extended ASCII character set
VT100: ASCII character set
VT100+: Extend VT100 to support color,
function keys etc.
VT-UTF8: uses UTF8 encoding to map
Unicode chars onto 1 or more bytes.
[VT100, VT100+, VT-UTF8, ANSI]
Bits per Second>
Selects the serial port transmission
speed. The sped must be matched on the
other side. Long or noisy lines may require
lower speeds.
[9600, 19200, 38400, 57600, 115200]
Data Bits>
Data Bits
[7, 8]
Parity>
A parity bit can be sent with the data bits
to detect transmission errors.
Even: parity bit is 0 if the num of
1’s in the data bits is even.
Odd: parity bit is 0 if the num of
1’s in the data bits is odd.
Mark: parity bit is always 1.
Space: Parity bit is always 0.
Mark and Space Parity do not allow error
detection. [None , Even, Odd, Mark, Space]
Stop Bits>
Stop bits indicate the end of a serial data
packet. (A start bit indicates the
beginning).
The standard setting is 1 stop bit.
Communication with slow devices may
require more than 1 stop bit.
[1, 2]
Flow Control>
Flow control can prevent data loss from
buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal
can be sent to stop the data flow. Once
the buffers are empty, a 'start' signal can
be sent to re-start the flow. Hardware
flow control uses two wires to send
start/stop signals.
[None, hardware RTS/CTS]
Содержание COMe-bEP7
Страница 1: ...USER GUIDE COMe bEP7 Module Doc Doc ID BEP7M102...
Страница 2: ...COMe bEP7 Module User Guide This page has been intentionally left blank...
Страница 27: ...COMe bEP7 Module User Guide www kontron com 27 Figure 2 Bottom View of COMe bEP7 5 2x COMe interfaces...
Страница 52: ...COMe bEP7 Module User Guide www kontron com 52 HOT Surface Do NOT touch Allow to cool before servicing...
