63
3.
Remove the bridge board from the chassis by opening the connector latch clips at
both ends of the board to free the board. (Figure 58, “A”)
The FP board connector latch clip is under the top edge of the chassis front panel.
You cannot see it, but you can feel the latch and unhook it from the board.
Figure 58. Removing the Bridge Board from the Chassis
Re-Installing the Bridge Board
To replace the bridge board back into the chassis:
1.
Align the bridge board edge connectors with the latch clip headers on the FP board
and the baseboard.
Make sure that the keying slot in the rear bridge board edge connector aligns with
the key in the baseboard header.
2.
Press down to make a firm connection at both ends of the bridge board and refasten
the connector latching clips on each end. (See Figure 58.)
