Könner & Söhnen KS 2100i S, Руководство пользователя

Страница: 23 / 82

Place the container with gas only vertically, according to the instruc -
tion manual for gas cylinders. The horizontal placement of gas cylin-
ders leads to hybrid generator gearbox failure.
IMPORTANT!
The ECON switch must be set to “OFF” to increase engine speed to
nominal. When connecting multiple power consumers to the generator,
be sure to first connect the one with the highest starting current, and
the device with the lowest starting current should be connected last.
IMPORTANT!
ECON FUNCTION ECON FUNCTION
1. Start the engine.
2. Set the ECON switch to “ON”. 3. Plug the device into an AC outlet.
4. Make sure the AC indicator light is on.
5. Turn on the electrical device.
FUNCTIONAL DESCRIPTION
OF INVERTER GENERATORS
8
For models with electric start, check if the battery is charged. If necessary, recharge the battery with a dedicated charger for lithium-ion
batteries or start the generator with a manual start and allow it to run idle while it is recharging.
“ON” MODE “ON” MODE
When the ECON switch is in the “ON” position, the control unit monitors the engine speed, reducing it commensurate with the connected
load. If the engine speed is not enough to generate electricity to provide the load, the control unit will automatically increase the engine
speed.
As a result, fuel consumption is optimized and noise levels are reduced.
“OFF” MODE “OFF” MODE
The ECON switch must be set back to “OFF” when using electrical devices requiring a high starting current, such as a compressor or
submersible pump.
The ECON switch must be set back to “OFF” when using electrical
devices requiring a high starting current, such as a compressor or
submersible pump.
IMPORTANT!
DISCONNECT ALL DEVICES BEFORE STOPPING THE GENERATOR! DISCONNECT ALL DEVICES BEFORE STOPPING THE GENERATOR!
Do not stop the generator with the devices turned on. This may disable the generator or devices connected to it!
PARALLEL FUNCTION PARALLEL FUNCTION
The total output power of the generators can be increased by connecting two inverter generators together using the Parallel Unit from
Könner & Söhnen. Parallel connection of two generators ensures total rated output power of these generators. When the generators are
connected in parallel, the power loss is 0.3 kW of the total rated power that can be obtained.
TO START LPG/GASOLINE GENERATOR IN GASOLINE MODE TO START LPG/GASOLINE GENERATOR IN GASOLINE MODE FOR MODEL FOR MODEL KS 5500 KS 5500iiEG S EG S
1. Ch eck oil level.
2. Check fuel level.
3. Set the fuel switch FUEL CHOICE to GASLONE.
4. For manual start turn MAIN POWER button to “ON” position, pull the manual starter until a slight resistance is felt, then pull it toward
you relatively sharply. Slowly turn the manual starter by hand, do not release it abruptly.
4.1. For electric start - turn MAIN POWER button to “ON” position, then press the ELECTRIC START button.
Fuel switch should only be performed with the load off.
IMPORTANT!
The generator is supplied with disconnected battery. When using the
generator for the first time, open the maintenance door and connect
the battery line. For long-term storage of generator, disconnect the
battery line (for models KS 5500iES ATSR, KS 5500iEG S).
IMPORTANT!
TO START LPG/GASOLINE GENERATOR IN GASOLINE MODE TO START LPG/GASOLINE GENERATOR IN GASOLINE MODE (KS 2100 (KS 2100 ii G S, KS 3100 G S, KS 3100 iiG S) G S)
1. Close the gas valve on the cylinder.
2. Open the vent on the fuel cap to the “ON”.
3. Turn the Multifunctional engineswitch to the “START” position (fig. 2).
4. Pull the manual starter until a slight resistance is felt, then pull it toward you relatively sharply. Slowly turn the manual starter by hand,
do not release it abruptly.
5. Turn the Multifunctional engineswitch to the “RUN ” position .
www.ks-power.de/en
| 22