CMP-WNAP10
54M Wireless Access Point User Guide
-
7
-
Supports Remote and Web management
2.3 Panel Layout
2.3.1 The Front Panel
Viewed from left to right, as shown in figure 2-1, the front panel of the CMP-WNAP10
consists of four LEDs, which is designed to indicate connections. Table 2-1 describes the
LEDs on the front panel of the AP.
Figure 2-1: Front Panel sketch
Name
Action
Description
Not lit
No Power
POWER
Lit up
Power on
Lit up
The AP is initialising
Flashing
The AP is working properly
SYSTEM
Not lit
The AP has a hardware error
Not lit
There is no device linked to the corresponding port
Lit up
There is a device linked to the corresponding port but no
activity
LAN
Flashing
There is an active device linked to the corresponding port
Not lit
The Wireless Radio function is disabled
WLAN
Flashing
The Wireless Radio function is enabled
Table 2-1 The LEDs description
2.3.2 The Rear Panel
The rear panel contains the following features: (Viewed from left to right in figure 2-2)
Wireless antenna
Factory Default Reset button
There are two ways to reset the AP's factory defaults:
1) Use the
Factory Defaults
function on
System Tools
->
Factory Defaults
page
in the AP's Web-based Utility.
2) Use the Factory Default Reset button: First, turn off the AP's power. Second,
press and hold the default reset button then turn on the AP's power, until the
system LED lights up (about 3 seconds). Last, release the reset button and wait
for the AP to reboot.
Note
: Ensure the AP is powered on before it restarts completely.
One LAN 10/100Mbps RJ45 port for connecting the AP to hub or switch
AC power socket: only use the power adapter supplied with the CMP-WNAP10
54Mbps Wireless Access Point, use of a different adapter may result in product
damage.
