CMP-WNAP10
54M Wireless Access Point User Guide
-
9
-
Chapter 3: Connecting the AP
3.1 System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable Modem that has an RJ45 connector
A Ethernet broadband router
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator
6.0 or later
802.11g or 802.11b-compliant devices, such as the CMP-WNUSB10 Wireless
Adapter
3.2 Installation Environment Requirements
Not
in direct sunlight or near a heater or heating vent
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on
all sides of the AP
Well ventilated (especially if it is in a closet)
Operating temperature: 0
℃
~40
℃
(32
℉
~104
℉
)
Operating Humidity: 10%~90%RH, Non-condensing
3.3 Connecting the AP
Figure 3.1 is an example of an infrastructure network incorporating the CMP-WNAP10.
An Infrastructure network contains an access point or a wireless router. For a typical
connection of the AP, please do the following:
1. You will need broadband Internet access (a Cable or DSL-subscriber line into your
home or office). Consult with your Cable or DSL provider for proper installation of the
modem.
2. Connect the Cable or DSL modem to a Router. Quickly install the router.
3. Locate an optimum location for the AP. The best place is usually near the center of
the area in which your PC(s) will wirelessly connect. The place must accord with the
Installation Environment Requirements
.
4. Adjust the direction of the antenna. Normally, upright is a good direction.
5.
Connect the Ethernet Broadband Router to the CMP-WNAP10 AP. Power on the AP.
6. If you are connecting a desktop PC or laptop to your network, install the KÖNIG
Wireless Adapter on the PC.
