Konica Minolta SONIMAGE HS2, Руководство по эксплуатации

Страница: 75 / 308

75
Chapter 2
This system receives power either from a commercial
power source (via the AC adapter) or from a battery .
Battery connection is composed of a three-element
combination: the system, battery and AC adapter .
WARNING
•••••••••••••••••••••••••••••••••••••
• Be sure to use the power supply cord that is in-
cluded with the system, and connect the mains
plug (Hospital Grade) to a wall mounted AC socket
outlet . Do not connect the mains plug to a two-pin
socket outlet using conversion adapters, etc . Doing
so may cause an electric shock .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
2 .2 .1 Connecting the Battery
1
Slide the knobs to toward each side of the
system to remove the battery cover .
Knobs
Battery cover
IMPORTANT •••••••••••••••••••••••••••••••••••••
• A battery authorized by Konica Minolta must be
used .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
2
Install a battery by holding its grips .
• The battery has the specified orientation. Insert
its terminal side first.
Terminal side
Grips
3
Close the battery cover .
2 .2 Power Supply Cord Connection and Battery Capacity
z
How to remove
In step 2, hold the grips to remove the battery from the
system .
2 .2 .2 Connecting the AC Adapter
1
Connect the AC adapter connector to the
system’s power connector until you hear
it click .
AC adapter
connector
Power connector
IMPORTANT •••••••••••••••••••••••••••••••••••••
• An AC adapter authorized by Konica Minolta must
be used .
• Make sure to fully insert the AC adapter connec-
tor . If the connection is incomplete, the AC adapter
connector may become extremely hot .
• Although the AC adapter becomes hot during use, this
is normal as long as the indicator lamp is lit in green .
• When using the system on a desktop, keep the
AC adapter about 10 cm or more away from the
transducer . Otherwise, noise may be present in the
ultrasound image .
• To use an optional Pole Cart2, route the AC adapt-
er cable and the power supply cord as shown in
the figure below. Fixing the cable in a place other
than specified may damage the cable or other parts
when you adjust the height of the Pole Cart2 . If
you removed the AC adapter cable and the power
supply cord, connect them as shown next, in ac-
cordance with your option combination .