Kongsberg Simrad ES80, Руководство по установке, Страница: 45 / 312

416739/A
43
Note
The installation shipyard must provide all necessary design and installation drawings,
as well as the relevant work standards and mounting procedures. If required, all
documents provided by the shipyard for the physical installation of the ES80 must
be approved by the vessel’s national registry and corresponding maritime authority
and/or classification society. Such approval must be obtained before the installation
can begin. The shipowner and shipyard doing the installation are responsible for
obtaining and paying for such approval.
Relevant installation drawings are included with each transducer. The drawings
(normally in AutoCad format) can be downloaded from our website.
3 Install the ES80 system units.
Note that some ES80 system units may be commercial. Unless ordered specifically
these are not included in the delivery, and must be purchased locally.
• Installing the ES80 hardware units, page 64
4 Install the cables between the ES80 system units.
Observe the relevant cable plan, procedures, as well as the general requirements for
cabling. This is described in the
Cable layout and interconnections chapter. Observe
the relevant cable plan, procedures, as well as the general requirements for cabling.
• Cable layout and interconnections, page 79
5 Install the cables between the ES80 and the relevant peripheral devices.
6 Turn on the ES80 for the first time, and set it to work.
Note
In order to turn on the ES80 in a safe and correct manner, the relevant procedures
must be complied to!
• Setting to work, page 153
7 Do a complete ES80 system test.
The tests are described in Setting to work chapter in this manual. They are also provided
in the Harbour Acceptance Test and the Sea Acceptance Test documents.
• Setting to work, page 153
Further requirements
Fill in and sign the Installation Remarks form, and send it to the Simrad support department
as specified on the form.
Preparations