25
3. Pressing the "Read" button reflects the
setting values in the servo to the man-
ager. If it succeeds "Read completed" is
displayed in the lower left column. If it
fails, "Failed to acquire" is displayed,
please check the procedure and press
the "Read" button again. Please be es-
pecially careful that the Dual USB
adapter HS is not "Serial mode (Green
LED)".
5. Please press "Write" button. It will be
completed if "dialogue success" is dis-
played. Please close the dialog with OK
button.
This is how to change the baud rate setting.
Repeat the procedure to change the baud rate of all servos. When all the work is done,
be sure to quit the software and remove the Dual USB Adapter HS from the PC.
*Since these changes are only for setting changes, it communicates with the bus
power of the PC, but please connect a battery when checking the operation of the
servo. For the connection method and cables required, refer to the manual attached to
the servo manager.
4. Select "1.25 Mbps".
Assembly
