Komatsu WA470-7, Инструкция по сборке

Страница: 22 / 43

5
×
NO.0050
Adjustment of work equipment EPC lever detent
position
6
×
Assembly procedure
*Perform the following correction with the engine stopped.
⑤
-3. Lower the boom to the ground.
⑥
-3. Stop and hold the bucket lever just before the TILT detent position.
⑦
-3. Press the ENTER switch, and the lever voltage is read and the standard value is
changed and saved.
⑧
-3. When the display changes to "1", setting is completed.
[Adjustment of bucket tilt detent position]
Bucket Tilt Adjustment
1
0: Waiting
1: OK
2: NG
⑨
-3. If the ENTER switch is pressed while the lever output voltage is below the standard
value (out of the design range) the display changes to "2" and adjustment is canceled
Q'ty Name Q'ty
Others
3
×
Precautions Tools to be used
Name
Facilities to be used
4
×
*Perform the following correction with the engine stopped.
⑤
-3. Lower the boom to the ground.
⑥
-3. Stop and hold the bucket lever just before the TILT detent position.
⑦
-3. Press the ENTER switch, and the lever voltage is read and the standard value is
changed and saved.
⑧
-3. When the display changes to "1", setting is completed.
[Adjustment of bucket tilt detent position]
Bucket Tilt Adjustment
1
0: Waiting
1: OK
2: NG
⑨
-3. If the ENTER switch is pressed while the lever output voltage is below the standard
value (out of the design range), the display changes to "2" and adjustment is canceled.
Bucket Tilt Adjustment
0: Waiting
1: OK
2: NG
2
⑩
-3. Finish the adjustment mode with the RETURN switch.
If the RETURN switch is pressed during adjustment, adjustment is finished even in the
calibration process.
Others
1 × 2 ×
*Perform the following correction with the engine stopped.
⑤
-3. Lower the boom to the ground.
⑥
-3. Stop and hold the bucket lever just before the TILT detent position.
⑦
-3. Press the ENTER switch, and the lever voltage is read and the standard value is
changed and saved.
⑧
-3. When the display changes to "1", setting is completed.
[Adjustment of bucket tilt detent position]
Bucket Tilt Adjustment
1
0: Waiting
1: OK
2: NG
⑨
-3. If the ENTER switch is pressed while the lever output voltage is below the standard
value (out of the design range), the display changes to "2" and adjustment is canceled.
Bucket Tilt Adjustment
0: Waiting
1: OK
2: NG
2
⑩
-3. Finish the adjustment mode with the RETURN switch.
If the RETURN switch is pressed during adjustment, adjustment is finished even in the
calibration process.
19