Komatsu 75001, Руководство по ремонту

Страница: 519 / 1293

SEN03838-00
30-130
46
WA250, 250PZ-6
130 Testing and adjusting, Part 3
Special functions of machine monitor (EMMS)
List of maintenance items
4) Settle the target items of interval change
by use of [
U ] switch.
5) Maintenance interval time change proce-
dure
1]
This cursor is located at the highest-
order digit. Pressing [<] or [>] switch
changes the value of this digit in the
range of 0 – 9.
2] Press [ U ] switch when the intended
value appeared to specify it as the set
value.
a The cursor moves to the 2nd digit.
3] Set the values up to the lowest-order
digit in the same order and then press
[
U ] switch.
q
When the input interval time is within
t h e s e t t i n g r a n g e : T h e s c r e e n
changes to the check screen.
q
When the entered interval time is out
of the setting range: The entered
interval time does not replace the cur-
rent value and the input screen will be
restored.
a The shortest interval time value is 50 h.
a When you have entered a wrong value to
a position except the highest-order digit,
move to the highest-order digit using [
t ]
switch and repeat the procedure from the
first. In this case, the value that had been
entered remains as it is until modified.
When the cursor is at the highest-order
digit, move to the higher layer using [
t ]
switch.
Item ID No.
Indication of items on the
character display
Replacement
interval time (H)
Engine oil 01 ENG OIL 500
Engine oil filter 02 ENG FILT 500
Fuel pre-filter 41 FUEL P FILT 500
Fuel filter 03 FUEL FILT 1000
Corrosion resistor 06 CORR RES 1000
Transfer oil 25 TRANSF OIL 1000
HST oil filter 26 HST FILT 1000
Hydraulic oil filter 04 HYD FILT 2000
Hydraulic oil 10 HYD OIL 2000
Axle oil 15 AXLE OIL 2000
HST drain filter 43 HST DR FILT 2000