8.6.2 Auxiliary voltage power supply 24 VDC (X10)
The following diagram describes external 24 VDC power supply (PELV). The required supply
current rating depends on the use of motor brake (
2 pin, pitch 5.08 mm
Mating connector data see (
Undervoltage fault limit 19 V
Overvoltage fault limit 30 V
Pin Signal
Description
1
+ 24 V
+24 VDC supply voltage, PELV
2
GND
Ground for 24 VDC supply voltage, PELV
8.6.2.1 Fusing
Use 24 VDC supply manufacturers recommendation for fusing.
24 V supply (PELV)
Units
Input data
single axis
Input data
dual axis
Aux. voltage supply (PELV)
VDC
24 V (±10%, check voltage drop)
- control current without motor brake
A
1
1.25
- control current with one motor brake
A
3.5
3.75
8.6.2.2 Wiring example 24 VDC supply
Example for three phase power supply unit.
8.7 DC Bus link (X3)
Beta Drives: DC Bus sharing functionality is pending. Do not use this functionality until fur-
ther notice.
AKD2G-S Installation, Safety 1 | 8 Electrical Installation
Kollmorgen | kdn.kollmorgen.com | Beta, December 2018
75