19
1058907-W2-J
Lever Shut Off Position
1.
Turn the lever fully to the off position. Remove plug and slacken the grub screw
which secures the lever, and remove the lever.
2.
Refit the lever to the spindle one serration anticlockwise (approx 10
degrees).
3.
Turn the lever fully clockwise to the stop (lever should be parallel with the wall)
and ensure that tight shut off is achieved.
4.
If tap continues to drip repeat the above procedure, adjusting the lever one
further serration.
5.
After adjusting the lever position it may be necessary to adjust the maximum
temperature stop. Refer to section:
'Commissioning'
.
6.
If tap continues to drip, replace the internal seals. Refer to
Maintenance
Procedure - Internal Mechanism.
Maintenance Procedure - Internal Mechanism
Removal
1.
Isolate the hot and cold supplies, and move the lever to its mid position to
release any pressure.
2.
Remove the plug in the side of the lever and use a 2.5 mm A/F hexagonal
wrench to loosen the grub screw. Remove the lever.
3.
Pull the collar and stop ring off the head assembly.
4.
Use a suitable spanner to remove the head assembly.
5.
Remove the circlip and screw from the head assembly.
6.
Push the rising and non-rising spindles out of the head.
7.
Insert the 2.5 mm A/F hexagonal wrench into the grub screw in the centre of
the rising spindle.
8.
Rotate the grub screw clockwise until it pushes the follower out of the rising
spindle. Remove the thrust washer.
9.
DO NOT unscrew the rising and non-rising spindles from each other, or remove
the 'black' grease as these are 'greased for life' during manufacture.
10.
Carefully remove the 'O' seals from the head, the non-rising spindle, the rising
spindle and the follower.
Do not
remove the 'O' seal in the bottom face of the
rising spindle at this stage (refer to paragraph 15). This 'O' seal forms the cold
seat for the Thermotap-3 and the groove is swaged to hold it in position.
11.
Withdraw the shuttle/thermostat assembly, complete with return spring, from
the Thermotap-3 body. Do not disassemble the shuttle/thermostat assembly.
12.
Carefully remove the retainer, the separator 'O' seal and the hot seat from the
Thermotap-3 body. Take care not to damage the seal grooves.
