Kohler Rada 215 Series, Руководство по эксплуатации продукта

Страница: 13 / 32

13
1057616-W2-J
12. Remove the two shroud screws (retain for later
use) and remove the building-in shroud from
the mixer.
13. Make sure that the olives are fitted, connect
the hot and cold supply pipes and tighten the
compression nuts.
14.
Connect the outlet pipework, leaving enough
pipe through the wall to temporarily cap off.
15.
Turn on the water supplies and check for leaks.
16. Attach the building-in shroud to the mixer using
the two shroud screws removed earlier.
17. Using the ‘Finished Wall Indicator’ on the
building-in shroud as a guide, finish the wall,
e.g. tiles.
Caution! Make sure that the finished wall is
within the maximum and minimum limits and to
an even depth (no greater than 2 mm variation)
or the control components will not fit correctly.
6. Refit the building-in shroud to the mixer.
7. Make sure that the mixer is level and central
in the hole, and square to the finished wall
surface (or the control components will not fit
correctly), then mark the positions of the three
fixing screw holes on the wall.
8. For solid walls drill three 6 mm holes for the
wall plugs.
9. Fit the hot and cold supply pipework ( Hot -
Left, Cold - Right ).
10. Caution! It is essential at this point
that the supply pipework is thoroughly
flushed through before connection to the
mixer. Failure to do so may result in product
malfunction and will not be covered under the
guarantee.
11. Insert the wall plugs and attach the mixer to
the wall with the screws provided.
Note! For stud partition installations alternative
fixings may be required (not supplied) to fix the
mixer to the rear face of the wall cavity or to a
timber noggin.
Finished Wall Thickness
(e.g. tile and adhesive)
Wall Cutout Depth
‘X’
4 mm 81 - 63 mm
6 mm 79 - 61 mm
8 mm 77 - 59 mm
10 mm 75 - 57 mm
12 mm 73 - 55 mm
14 mm 71 - 55 mm
16 mm 69 - 55 mm
18 mm 67 - 55 mm
20 mm 65 - 55 mm
22 mm 63 - 55 mm
24 mm 61 - 55 mm
Screws
Outlet Pipe to
Fittings
Hot Supply
Cold Supply
Minimum finished
wall surface
Finished Wall
F9802
Min
Max
Maximum finished
wall surface