Kohler Mira Miniduo, Инструкция по установке и эксплуатации

Страница: 10 / 28

10
Exposed Thermostatic Mixers
For Built-in Thermostatic Mixers go to section:
‘Installation, Built-in Thermostatic Mixers’ .
1. The thermostatic mixer can be installed with
rear, rising or falling supply inlets. Decide
on the most appropriate method for your
installation, and if necessary, loosen the
grubscrews and rotate the inlet elbows to
suit.
Important!
Make sure that the elbows are
pushed fully onto the mixer before tightening
the grubscrews, do not overtighten.
2. Use the installation template to mark the
positions of the holes for the backplate and
the pipe centres.
For rising or falling supplies the pipe positions
should be set 39 mm from the centre of pipe
to the finished wall at 110 mm centres.
Note! If you are retro-fitting your mixing valve
onto existing pipework, an
Adjustable Elbow
Pack is available if required, refer to section:
‘Accessories’ .
39 mm
3.
For solid walls drill the holes for the backplate
with a 6 mm drill and insert the wall plugs
(supplied). For other types of wall structure
alternative fixings may be required (not
supplied).
6 mm Drill
Wall Plug
4. For Rear Entry Supplies Only:
a) Drill the holes for the supply pipes at
110 mm centres.
Note! Recess the inlet holes Ø19 mm x
2 mm deep to allow for the concealing
plates.
5. Fit the supply pipework: Hot - Left, Cold
- Right. The inlet pipework should extend
23 mm from the finished wall surface.
Note! If it is not possible to install the
mixer with this pipework configuration follow
instruction 6.
23 mm from finished
wall surface
Elbow
Recess Ø19 mm
x 2 mm deep
23 mm
110 mm
HOT
COLD