Kohler Mira Honesty, Инструкция по установке и эксплуатации

Страница: 14 / 20

14
1333238-W2-A
Commissioning
Hub
Fixing Screw
Hot +
Cold -
Temperature Knob
Inside View of
Temperature Knob
Maximum Temperature Setting
Follow this procedure to check and adjust the temperature before using the shower
for the first time. Make sure that all users are familiar with the operation of the
shower. This guide is the property of the homeowner and must be left with
them following installation completion.
The shower’s maximum temperature has been preset to 46°C, but may require
adjustment for the following reasons:
•
To reset to a comfortable temperature (may be required to suit the
plumbing system).
•
To suit your showering preference.
The following procedure requires a constant supply of hot water at a minimum
temperature of 55°C.
1.
Turn the shower
ON
to full flow.
2. Turn to full hot. Allow the temperature and
flow to stabilise.
3. To set the temperature to either warmer
or cooler, pull off the temperature
knob taking care not to rotate the hub.
Note! Take care not to damage the chrome
if a tool is used to lever off.
4. To increase the temperature, rotate the hub
in an anticlockwise direction, colder turn
clockwise. Make small adjustments and
allow temperature to settle before making
further adjustments. Continue to adjust until
the required temperature is achieved.
5. Remove the fixing screw securing the hub
and refit aligning the hub as shown. Clips to
be orientated in the 3, 6, 9 and 12 O'clock
positions.
6 . Retighten the fixing screw without rotating
the hub.
7 . Push on the temperature knob making sure
that it locates correctly.
Note! The arrow on the inside of the handle
should point downwards.
8 . Rotate the temperature knob to full cold
then rotate back to full hot and check the
maximum temperature is set correctly.
Clips
Clips