Reassembly
113
62 690 05 Rev. E
KohlerEngines.com
Install Governor Shafts, Seal, and Governor Gear
(Mechanical Governor only)
Governor Components and Details
A
Crankcase Surface
B
Seal Depth
1.5-2.0 mm
(0.059-0.078 in.)
C
Oil Seal
D
12.66 mm
(0.498 in.)
E
Crankcase Surface
F
Governor Gear
Shaft
A
C
B
F
D
E
If governor shafts, seal, and/or governor gear were
removed, reassemble as follows.
1. Lightly oil lip and outside diameter of new governor
cross shaft seal. Install seal into crankcase to depth
shown.
2. If governor gear shaft was removed, press or lightly
tap replacement shaft into oil pan to depth shown.
3. Lubricate governor cross shaft bearing surfaces in
crankcase with engine oil. Insert governor cross
shaft end with fl at cutout where governor yoke is
secured, into crankcase and position shaft so that
fl at part is visible (up).
4. Attach governor yoke to cross shaft so curved
section is up as marked. Secure with screws. If a
thread locking compound is not preapplied, apply a
small amount of Loctite
®
266™ Threadlocker or
equivalent, to screw threads before installing. Torque
screws to 2.2 N·m (20 in. lb.).
5. Install fi rst regulating pin with head down so it will
contact yoke. Install governor gear with second
regulating pin and fl yweight assembly in/down onto
governor shaft until it locks into position. Apply a
small amount of grease to locking tab thrust washer
and install on top of governor gear so tang is facing
up in 6 o’clock position.
NOTE: Make sure engine is assembled using all
specifi ed torque values, torque sequences, and
clearances. Failure to observe specifi cations
could cause severe engine wear or damage.
Always use new gaskets. Apply a small amount
of oil to threads of critical fasteners before
assembly, unless a sealant or Loctite
®
is
specifi ed or preapplied.
Make sure all traces of any cleaner are removed before
engine is assembled and placed into operation. Even
small amounts of these cleaners can quickly break down
lubricating properties of engine oil.
Check oil pan, crankcase, cylinder heads, and valve
covers to be certain all old gasket material has been
removed. Use gasket remover, lacquer thinner, or paint
remover to remove any remaining traces. Clean surfaces
with isopropyl alcohol, acetone, lacquer thinner, or
electrical contact cleaner.
Install Flywheel End Oil Seal
1. Make sure seal bore of crankcase is clean and free
of any nicks or burrs.
2. Apply a light coat of clean engine oil to outside
diameter of oil seal.
3. Install oil seal into crankcase using a seal driver.
Make sure oil seal is installed straight and true in
bore and tool bottoms against crankcase.
Install Lifter Feed Chamber Gasket and Cover
1. Install lifter feed chamber gasket, followed by lifter
feed cover over lifter feed chamber.
2. Install screws. Make sure all parts are properly
aligned. Torque screws to 6.6 N·m (58 in. lb.).
