Kohler Aegis ELH775, Руководство по обслуживанию

Страница: 80 / 104

80
Disassembly/Inspection and Service
KohlerEngines.com 66 690 14 Rev. A
Crankcase Components
H
A
C
D
E F
G
O
S
T
U
V
K
A
R
Q
L
N
M
I
B
P
W
J
A Oil Seal B Closure Plate C Governor Gear Shaft D
Locking Tab Thrust
Washer
E Governor Gear F Regulating Pin G Camshaft H Ball
I Spring J Oil Pump Cover O-ring K Outer Gerotor Gear L Oil Pump Assembly
M Oil Pick-Up N Nipple O Crankshaft P Dowel Pin
Q Governor Cross Shaft R Camshaft Seal S Piston Pin Retainer T Piston Pin
U Connecting Rod V Piston W Piston Ring Set
Remove Closure Plate
1. Remove screws securing closure plate to crankcase.
If a thick washer is installed under screw head in #10
location, and/or one silver (ground) screw is used,
(normally No. 4 or 6 position), note these special
assembly details for proper reassembly later.
2. Locate three splitting tabs, which are cast into
perimeter of closure plate. Insert drive end of a 1/2"
breaker bar between top splitting tab and crankcase.
Hold handle horizontal and pull it toward you to
break RTV seal. If necessary, pry at bottom splitting
tabs also. Do not pry on sealing surfaces, as this
could cause leaks. Carefully pull closure plate from
crankcase.
Inspection
Inspect oil seal in closure plate and remove it if it is worn
or damaged.
Inspect main bearing surface for wear or damage.
Replace closure plate assembly if required.