Koer C35-VAV..., Техническое руководство

Страница: 5 / 23

8
C35-VAV 9 C35-VAV
5. Mounting Instructions
Component Listing:
Component Description Quantity
1 Codis 35 1
2 Wall mount bracket 1
3 Screws 4
4 Wall plug / screw anchor 2
Inspect your package to ensure all components are present and that the connection terminals meet the
required specifications shown below. See Section 4 (page 7) for appropriate mounting locations.
Warning: Disconnect the power supply prior to commencing installation of the wall mount or
any wiring.
1. Place the wall mount on the conduit box (ø 60.3mm) and insert two screws which are provided.
NOTE : Alternate screws with the parameters shown above (right) can be used.
2. Connect the wires from the conduit box wall mount terminals using the relevant wiring
diagram on page 31.
Connection terminal
wire specifications Single stranded wire 0.2 … 1.5 mm
2
Fine stranded wire 0.2 … 1 mm 2
Captive screw M2
Screwdriver mm
Figure 5.1.
Figure 5.2.
IMPORTANT : Before proceeding to the next step, verify all connections are in the correct
terminals and that the correct voltage is being provided.
3. Attach C35-VAV… to the wall mount by sliding the unit onto the mounting brackets as
shown in the diagrams below. The unit will click into position. Turn on the power supply
and the unit will automatically turn on.
4. To remove or detach device from the wall mount, press the release bracket on the
bottom of the device and then pull the device upwards.
Warning : Ensure that the power supply has been switched prior to removing the device from
the wall mount.
Figure 5.3.
Figure 5.4.
CODIS35v4.4
WEIGHT:
A4
SHEET 1 OF 1 SCALE:1:5
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE SIGNATURE NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH: UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
A
DETAIL A
SCALE 2 : 1
CODIS35v4.4
WEIGHT:
A4
SHEET 1 OF 1 SCALE:1:5
DWG NO.
TITLE:
REVISION DO NOT SCALE DRAWING
MATERIAL:
DATE SIGNATURE NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH: UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN