27
5. Check for oil, coolant, and fuel leaks, Correct any leaks prior to proceeding
further.
6. Check charge and fluid level of battery. Inspect connections for corrosion,
and clean as necessary.
7. Clean crankcase vent system PCV valve.
8. Check air cleaner Make sure that it is cleaned replaced as necessary.
9. Inspect the exterior of the heat exchanger clean if necessary.
10. Check alternator
11. Lubricate throttle linkage.
12. Remove and replace fuel filter.
13. Remove, clean, adjust, test, and/or replace spark plugs.
14. Check for loose bolts, nuts, or any loose pieces.
15. Start the bilge blower, let the blower run for 10 minutes.
16. Close engine cover.
800 Hour Inspection
Perform the following inspection at 800-hour interval.
WARNING:
Make sure key is not in ignition and no electrical
equipment is energized prior to any engine check or operation. Do not
energize engine prior to performing the following steps.
1. Open engine hatch cover and let compartment air out for ten minutes or
more.
2. Make sure that no electrical equipment is energized
3. Change engine oil and filter.
4. Check for oil, coolant, and fuel leaks, Correct any leaks prior to proceeding
further.
5. Check charge and fluid level of battery. Inspect connections for corrosion,
and clean as necessary.
6. Clean crankcase vent system replace PCV valve.
7. Check air cleaner Make sure that it is cleaned replaced as necessary.
8. Inspect the exterior of the heat exchanger clean if necessary.
9. Check alternator belt adjust if necessary.
10. Lubricate throttle linkage.
11. Remove and replace fuel filter.
12. Remove, clean, adjust, test, and/or replace spark plugs.
13. Remove and replace PCV valve.
14. Drain and replace coolant in cooling system.
15. Check for loose bolts, nuts, or any loose pieces.
16. Start the bilge blower, Let the blower run for 10 minutes.
17. Close engine cover.
